M3DVQ wrote:I have one of those drill bits with a plastic handle, but making all the cuts and then locating the inevitable barely visible short drives me round the bend.
I started using "tri pad" board for most prototyping now, though occasionally use the individual pad board too. It allows you to solder lots of DIL components at a good high density without having to cut hundreds of strip-board tracks, I'd never go back to stripboard now
Harry Dalek wrote:I use copper wire( strand of copper wire from a power cable) for the circuit tracks on the matrix board so i don't waste to much solder ,i only cross matrix tracks with solder if is a short distance .
Users browsing this forum: No registered users and 16 guests