Re: The Cyclops a Vidicon project
Posted: Fri Jul 06, 2018 3:57 pm
As far as adjustments go i have on the deflection ... size and position this is the best it will until i have a look at the deflection current limiting resistors,
Seems ok on vertical but the the horizontal line looks like its over shooting i will just try moving the Vidicon in the yoke just to make sure it is not that but it must be over scanning as Klass suggested before so i will increase the resistance on the yoke resistor on the horizontal line yoke .
Filming here one of my sons Charlie testing todays adjustments
looks like i might have the target wire arcoss one side the target area whoops !
Seems ok on vertical but the the horizontal line looks like its over shooting i will just try moving the Vidicon in the yoke just to make sure it is not that but it must be over scanning as Klass suggested before so i will increase the resistance on the yoke resistor on the horizontal line yoke .
Filming here one of my sons Charlie testing todays adjustments
looks like i might have the target wire arcoss one side the target area whoops !