I have left for a start the connections to and from deflection amplifiers to show them as is now ..i will after this post adjust and disconnect the ramp inputs to the amplifiers to show wave forms as mentioned in the last post but get these out of the way first
Steve I will first up just changed the one dead 47k resistor in the line defection amplifier ,very strange looks just to be a dud nothing wrong with it from looking at it but its open circuit somewhere inside it .
But this now shows the line deflection amplifier is back .
- DSCN6398.JPG (189.64 KiB) Viewed 8399 times
Out of the line ramp generator to deflection amp input
Next i looked at whats coming out of both deflection plates on the line side
- DSCN6403.JPG (235.69 KiB) Viewed 8399 times
- DSCN6402.JPG (213.07 KiB) Viewed 8399 times
Next the frame ramp out of ramp generators input to deflection amplifier
- DSCN6409.JPG (181.46 KiB) Viewed 8399 times
Now the the frame output of the defection amplifiers to crt plates not really good at all.. i will check for a wiring mistake seems too poor .
- DSCN6405.JPG (264.55 KiB) Viewed 8399 times
- DSCN6406.JPG (265.76 KiB) Viewed 8399 times
makes sense looking at the ramp out to how poorly the size and position control work on this amplifier