Parts list/cost

A "new fashioned" televisor, using an Arduino to drive the motor and display.

Moderators: Dave Moll, Andrew Davie, Steve Anderson

Parts list/cost

Postby Andrew Davie » Sat May 13, 2017 4:36 pm

Here's the list of components and my purchase cost in US$

Arduino atmega32u4 processor $3.82
TIP122 transistor $0.11
IRL540 mosfet $0.33
IR diode (pair) $0.11
5cmx7cm board x2 $0.52
terminal connectors (2pin) x 8 $0.45
LEDs (24 = 8x3 matrix) $0.57
resistors (various x 12) $0.30
Nextion 2.4" display $15.50
motor $0.91
MicroSD card class 10, 8GB $6.00
O-ring for drive belt $0.10
3D printed pulley pair $0.20
mount for motor $0.30

So that's all I can think of - total cost excluding BYO Nipkow disk + hub = US$30
Of course to get these prices I bought most items in buik. If you're doing a build....
User avatar
Andrew Davie
"Gomez!", "Oh Morticia."
 
Posts: 1590
Joined: Wed Jan 24, 2007 4:42 pm
Location: Queensland, Australia

Re: Parts list/cost

Postby Harry Dalek » Wed May 24, 2017 5:29 pm

Thats pretty good Andrew amazing ...theres always a problem repeating a design as i have found out mainly in mistakes in schematics ...here i can only think as with a normal televisor all motors are different here the problems may come .
The electromagnetic spectrum has no theoretical limit at either end. If all the mass/energy in the Universe is considered a 'limit', then that would be the only real theoretical limit to the maximum frequency attainable.
User avatar
Harry Dalek
"Fester! Don't do that to 'Thing'"
 
Posts: 5364
Joined: Fri Sep 26, 2008 4:58 pm
Location: Australia


Return to Andrew Davie's Arduino Televisor

Who is online

Users browsing this forum: No registered users and 1 guest

cron