Moderators: Dave Moll, Andrew Davie, Steve Anderson
McGee2021 wrote:I have recently acquired a 500 gallon air compressor, used in conjunction with a sandblaster large enough to fit a small office chair in. My hopes are to use this sandblaster, instead of the traditionally acetone and chloroform, to smooth some of my 3d printed parts, most notably the case and knobs. The face plate is going to be a rather difficult piece to 3d model, so i have thrown away hopes to print it, and instead make a mold of it. I have mentioned this before, i think, but i just feel that it fits into this post.
Return to Baird Lens Box and Face plate
Users browsing this forum: No registered users and 2 guests