Right Hand - Prototype
Posted: Sat Sep 02, 2017 11:39 pm
I've made a start! I have the CR-10 printer set up and it appears to be printing OK. I've just about finished printing the various upgrade parts for the printer itself, so I thought it was about time to download some of the 3D models for the INMOOV robot and get them printing. It's going to take hundreds and hundreds of hours of printing to do the whole thing, but hey... a journey starts with the first step.
I am printing in blue - just because that's the filament I have setup, and I consider this first print a "learning how" prototype. I'll try and print and assemble a right-hand, test the materials and tolerances, and find out what parts I need to purchase/modify.
So, here's a couple of images. One shows the first lot of parts for the hand (just the fingers and wrist, basically). The other shows the "historical" start of the first print
I am printing in blue - just because that's the filament I have setup, and I consider this first print a "learning how" prototype. I'll try and print and assemble a right-hand, test the materials and tolerances, and find out what parts I need to purchase/modify.
So, here's a couple of images. One shows the first lot of parts for the hand (just the fingers and wrist, basically). The other shows the "historical" start of the first print