I just remembered some where in control grid modulation its been swapped to cathode modulation well Klaas is a good negotiator.
So better make a new topic as the thing is built and almost read for testing .
I need Klass for you to have a look at the drawn schematic i think its pretty much what you mentioned in your last post well i hope i have got it right ! so i have drawn it up...my only worry is my general purpose BC549 BC558 transistor substitutes are good enough.
Also there were some resistor changes you mentioned for a 12 volt supply i was not sure if there will be a problem on the positive 12 side well we could give it a go and see as its together now .
BTW i did make as you see the 68k a higher wattage resistor also made the 33k one as i had it handy .
I will wait to hear back before hooking up the power supply in case i need to make changes .