gary wrote:well it is certainly a thing of beauty if nothing else.
BTW is the dome sensor(fss)/light source(mps) and the modulation source on the same axis? If not the picture will not be framed...
i.e.
---modulator-------DISK---------sensor/light source----
I was planning using both the dome sensors Gary ,i suppose distance apart would be more helpful picking up the light ,i did not really think about the placement of this apart from where it fits and can pick up the light ,so that has to be in line with the camera lens to one side ...theres gos sticking it on top if so .....if i am correct in saying that ?
I am still not too picky about the monitor side of it so long as i can see getting the camera in sync ,i know at the moment even with the extra half spiral i expect it will be out on the monitor but really haven't looked to much into this yet ...apart from thinking of adding a extra spiral below the camera one to line up with the monitor start position perhaps.
I was doing some of the monitor circuit tonight try and finish that off tomorrow ,need to do the motor speed control and work some thing out for the light projection....i would like to try and do this small depends how much light this thing needs...i have a small luxeon torch that gives out 190 lumens not sure what a projector gives out but must is more ..i wouldn't mind if its a in dark room only camera ..
The electromagnetic spectrum has no theoretical limit at either end. If all the mass/energy in the Universe is considered a 'limit', then that would be the only real theoretical limit to the maximum frequency attainable.