5AHP7A Vintage SSTV The Deep image
Posted: Mon Jan 04, 2016 8:16 pm
Still Wishful thinking in my title but this is the next 2016 build after my 3BP1 NBTV monitor is finished .
I checked the Heater pins for conductivity this is fine next finding a B/W TV CRT yoke that will fit this thing ,best i have found vintage wise 1956 TV yoke ,problem was the 5AHP7A plastic plug ,have to have a good look if its lined up with the tube size or not it would be a good reason the 60s yoke doesn't fit .
Bit of a conundrum the 50s yoke fits but the 60s would i think be better suited if i could get it other side of that plug but still might not fit anyway on the neck of the yube
First picture the 2 yokes i had lucky i had something large enough for the plug and neck...
Have to scrounge around for a few bits i still need a case of some sorts being one but no rushing my minds still on the 3BP1 monitor ...
I checked the Heater pins for conductivity this is fine next finding a B/W TV CRT yoke that will fit this thing ,best i have found vintage wise 1956 TV yoke ,problem was the 5AHP7A plastic plug ,have to have a good look if its lined up with the tube size or not it would be a good reason the 60s yoke doesn't fit .
Bit of a conundrum the 50s yoke fits but the 60s would i think be better suited if i could get it other side of that plug but still might not fit anyway on the neck of the yube
First picture the 2 yokes i had lucky i had something large enough for the plug and neck...
Have to scrounge around for a few bits i still need a case of some sorts being one but no rushing my minds still on the 3BP1 monitor ...