Getting the disc up to speed

A build to model parts for a Baird lens box, the type seen on televisors, suitable for 3D printing and use on a televisor model.

Moderators: Dave Moll, Andrew Davie, Steve Anderson

Getting the disc up to speed

Postby McGee2021 » Sat Dec 23, 2017 10:39 am

I had chance to run the motor up to a little past half speed, since i can not run it up to full speed without mounting and aligning the motor, something im not going to do until i have all of the parts mounted.
(139.75 MiB) Downloaded 284 times
John Logie Baird was obviously the man who sowed the seeds but did not reap the harvest.
User avatar
Just nod and pretend you understand me
Posts: 228
Joined: Wed Aug 12, 2015 9:41 am
Location: Tourist Trap Town

Re: Getting the disc up to speed

Postby Andrew Davie » Sat Dec 23, 2017 7:00 pm

Videos can be embedded on the site if they are "mp4" format. Upload the file, then grab the URL (right-click, copy address) and put that between start and end video tags. Like this... but replace the round brackets with square brackets... (video) If the video itself is "web optimised" then it will start streaming immediately instead of the viewer having to wait for it to completely load before playing.

(14.26 MiB) Downloaded 509 times
User avatar
Andrew Davie
"Gomez!", "Oh Morticia."
Posts: 1584
Joined: Wed Jan 24, 2007 4:42 pm
Location: Queensland, Australia

Return to Baird Lens Box and Face plate

Who is online

Users browsing this forum: No registered users and 2 guests